MIX EFFECTS UPGRADEInstallation ManualPROFILE FAMILYVIDEO FILE SERVERS071-8071-00NOVEMBER 2000
x Mix Effects InstallationFCC EmissionLimitsThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
Mix Effects Installation xiContents Kit Description...
Contentsxii Mix Effects Installation
Mix Effects Installation 1 Mix Effects InstallationKit DescriptionThis modification kit adds the Mix Effects circuit board to your Profile system.In a
Mix Effects Installation2 Mix Effects InstallationInstallation InstructionsNOTE: Product upgrades and repairs should only be attempted by qualified se
Removing the CoversMix Effects Installation 3Figure 1. Removing the Top Covers219496-1
Mix Effects Installation4 Mix Effects InstallationRemove the Circuit Board Retainers1. Take out the two screws shown in Figure 2 and then remove each
Installing the Mix Effects Circuit BoardMix Effects Installation 5Installing the Mix Effects Circuit Board 1. Select the slot to install your Mix Effe
Mix Effects Installation6 Mix Effects Installation2. Remove any circuit board or rear panel bracket installed in the desired Mix Effects slot. See Fig
Installing the Mix Effects Circuit BoardMix Effects Installation 7Figure 3. Circuit Board Retaining Screws 9607-312J6J7
Copyright Copyright © 2000 Grass Valley Group Inc. All rights reserved. Printed in the UnitedStates of America.This document may not be copied in whol
Mix Effects Installation8 Mix Effects InstallationVerificationInstall the software upgrade. See the Software Upgrade instructions supplied with this k
Mix Effects Installation iiiGrass Valley Group Product SupportYou can get technical assistance, check on the status of problems, or report new proble
iv Mix Effects Installation
Safety SummariesMix Effects Installation vWARNING: These instructions are for use by qualified service personnel only. To avoid personal injury, do n
vi Mix Effects InstallationAvoid ExposedCircuitryTo avoid injury, remove jewelry such as rings, watches, and other metallic objects. Do not touch expo
Service Safety SummaryMix Effects Installation viiSymbols on theProductThe following symbols may appear on the product:DANGER high voltageProtective g
viii Mix Effects InstallationCertifications and CompliancesCanadian CertifiedPower CordsCanadian approval includes the products and power cords approp
Laser ComplianceMix Effects Installation ixLaser ComplianceLaser SafetyRequirementsThe device used in this product is a Class 1 certified laser produc
Kommentare zu diesen Handbüchern